How to change kinetic energy into static electricity step by step?

Asked By: Cynthia Zemlak
Date created: Fri, Mar 26, 2021 3:56 AM
Best answers
Geothermal Thermal→ Mech→ Electricity 6-13% Wind Kinetic → Mech→ Electricity 30-60% Photovoltaic Cells Radiation → Electricity 10-15% Ocean Thermal Thermal→ Mech→ Electricity 1-3% Source: Sustainable Energy Sustainable Energy – Fall 2010 – Conversion 17
Answered By: Ignatius Johnston
Date created: Fri, Mar 26, 2021 4:55 PM
‘My idea was a floor tile that would convert the kinetic energy from a footstep into electricity,’ he says. ‘Every time someone steps on the tile, they generate 7W of power. The energy is stored within batteries, and then used to power lighting when it’s needed. It’s an off-grid power source for cities.’
Answered By: Dedrick Kuphal
Date created: Sun, Mar 28, 2021 6:36 PM
Well, You need a dynamo or alternator. A dynamo gives produces direct current, An alternator produces electric current. 2 parts are needed in both: - A stator & - A rotor The rotor spins while the stator is fixed. One of the 2 parts has...
Answered By: Susana Beatty
Date created: Mon, Mar 29, 2021 8:55 AM
The law of conservation of energy shows us that the maximum amount of energy at any point will not change regardless of how much of each type of energy is present, so if at maximum height, where only potential energy is present we calculate the energy as (100)(2)(-10)= 2000J, then the kinetic energy at max or right before the crate hits the water will also be 2000J.
Answered By: Dario Howell
Date created: Wed, Mar 31, 2021 8:43 AM
Example. Consider a mass of an object as 50 kg which travels with a velocity of 10 m/s at 5 seconds. The Kinetic energy can be calculated as. = 1/2 x 50 x (10x10) = 1/2 x 5000. = 2500. Converting to electrical energy, = 2500 / 5. = 500 Watts.
Answered By: Aurelie Welch
Date created: Thu, Apr 1, 2021 10:30 AM
In a turbine generator, a moving fluid—water, steam, combustion gases, or air—pushes a series of blades mounted on a rotor shaft. The force of the fluid on the blades spins/rotates the rotor shaft of a generator. The generator, in turn, converts the mechanical (kinetic) energy of the rotor to electrical energy.
Answered By: Peggie Mills
Date created: Thu, Apr 1, 2021 11:08 AM
What if there were a way to harness that kinetic energy, and turn it into ... What if you could take a small amount of energy from every step, ... and convert that into electricity that could ...
Answered By: Norma Fritsch
Date created: Sat, Apr 3, 2021 6:40 AM
By Steven Holzner. When an object falls, its gravitational potential energy is changed to kinetic energy. You can use this relationship to calculate the speed of the object’s descent. Gravitational potential energy for a mass m at height h near the surface of the Earth is mgh more than the potential energy would be at height 0.
Answered By: Gus Ledner
Date created: Sun, Apr 4, 2021 1:40 AM
Cut a hole in the lip of the cup so that when you turn it over on a table, there is a hole which a marble can now fit through, as shown in the previous diagram. Build the setup as shown in the following diagram. Place the cup upside down on the table surface. Place the ramp so that it ends at the hole in the cup.
Answered By: Jennie Hoppe
Date created: Tue, Apr 6, 2021 4:11 AM
Again, the first step is to set the equations for energy -- this time kinetic energy -- and work equal to each other and solve for force. W=KE=Fd=\frac{1}{2}mv^2 \implies F = \frac{1/2 mv^2}{d} The final step is to plug the values from the problem into the equation for force:
Answered By: Percival Bednar
Date created: Wed, Apr 7, 2021 9:43 PM
How Does a Nuclear Energy Plant Generate Electricity? The nuclear chain reaction produces heat inside the reactor vessel and heats water to a very high temperature. Due to pressure inside the system, the water does not boil.
A solar thermal system generates electricity indirectly by capturing the heat of the sun to produce steam, which runs a turbine that produces electricity. A solar photovoltaic system produces electricity directly from the sun’s light through a series of physical and chemical reactions known as the photovoltaic effect.
Most of U.S. and world electricity generation is from electric power plants that use a turbine to drive electricity generators. In a turbine generator, a moving fluid—water, steam, combustion gases, or air—pushes a series of blades mounted on a rotor shaft. The force of the fluid on the blades spins/rotates the rotor shaft of a generator.
Benjamin Franklin and Electricity. Electricity was on people's minds in the 1740s, but not in the way we think about it today. People used electricity for magic tricks by creating sparks and shocks. Scientists conducted experiments with electricity, but scientific thinking about electricity had not changed much in hundreds of years.


Ionic compounds conduct electricity when dissolved in water because the movement of their negatively-charged and positively-charged particles forms an electrical current, explains In this liquid state, the charged ions separate and move freely, creating a current of electrical particles that conducts electricity.
68 similar questions